American Audio DIGI-PRO Guida Utente Scaricare il pdf (Pagina 27)

Chapter 2: Installing ProControl 21

ProControl Input Connections

■ Connect the front left/right outputs to

ProControl Main In Left/Right (Audio In-

put 2, channels 7 & 8).

■ Connect the surround left/right channel

outputs to ProControl Source 1 In

Left/Right (Audio Input 2, channels 5 & 6).

■ Connect the center and sub channel out-

puts to ProControl Source 2 In Left/Right

(Audio Input 2, channels 3 & 4, respec-

tively).

ProControl Output Connections

■ Connect Control Room Main Out

Left/Right to the front left/right monitor

input channels.

■ Connect Control Room Alt Out

Left/Right to your surround left/right mon-

itor input channels.

■ Connect Aux Out Left/Right to your cen-

ter and sub monitor input channels.

When properly configured and connected,

ProControl will give you monitoring level

and in/out control over each pair of sur-

round stems using the control room sec-

tion.

About Source 1, 2 and 3 in Surround Mode

In Surround mode, the SOURCE 1 and

SOURCE 2 inputs are used for surround

and center/sub channel inputs. Source 3 In

is not used. To integrate other devices

while working in Surround mode, patch

the output of the device (DAT deck, or

other) to available inputs on your Pro Tools

audio interfaces.

Optional Connections

(All Modes)

Headphone

ProControl provides a stereo headphone

jack on the front panel. A discrete feed of

the main stereo ProControl mix, head-

phone level is set from the Headphone

knob in the Control Room section.

To connect headphones in a fixed installa-

tion (custom cabinets), you can use a right-

angle stereo phone plug.

Headphone output follows Control Room

MONO, but not control room MUTE or

DIM functions. This jack is not meant to

feed a cue system, but to allow a single pair

of headphones to be connected directly to

ProControl to monitor in private.

Footswitch

The SW 1 and SW 2 jacks can be assigned to

any of three available Footswitch func-

tions:

• Play/stop

• Record (punch-in/punch out)

• Remote Talkback on/off

Both footswitch inputs’ polarity is select-

able to support virtually any available mo-

mentary footswitch.

The function and polarity of the footswitch

jacks SW 1 and SW 2 are configured using

the ProControl UTILITY menus. Press

UTILITY > PREFS > SWITCH 1 (or

SWITCH 2) and configure the polarity and

functions. (See Appendix A: UTILITY Set-

tings for more information on UTILITY.)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 227 228

Commenti su questo manuale

Nessun commento