American Audio DTI 1.8 Specifiche Scaricare il pdf (Pagina 11)

SET-UP

Turntable Installation:

1. Do not place the unit in a location where it will be exposed to direct sunlight or near any type of

heating appliance.

2. Do not place the unit in a location where there is high humidity or a lot of dust.

3. Cartridge may pick up slight sound pressure or vibrations of near by speakers. For best results,

do not install this unit too close to speakers.

4. Install this unit on a horizontal surface that is stable and vibration free.

5. The rubber feet have been specially designed to isolate the unit from excess vibration. The feet

may also be used to stabilize the main body horizontally. Adjust the height of the unit by turning

the feet in a clockwise or counter-clockwise direction.

Tone arm Balance and Stylus Pressure:

Adjustment of horizontal zero balance and stylus pressure:

1. Remove the stylus protective cover, if so equipped. Never touch the stylus tip during the adjust

ment.

2. Lower the Tone arm Lever (24).

3. Release the tone arm clamp and release the tone arm from the arm rest.

4. Set the Anti-Skate (25) adjustment to zero.

5. Rotate the Counterweight (26) in either direction until the Tone arm (4) is perfectly balanced

horizontally (floats freely).

6. Return the Tone arm (4) to the arm rest and lock it in place.

7. Hold the Counterweight (26) stationary with one hand and rotate only the stylus-pressure ring to

bring the number “0” of the ring into alignment with the center line on the tone arm rear shaft.

8. Rotate the Counterweight (26) clockwise until the scale value corresponding to the recommend-

ed stylus pressure.

Note: The recommended stylus pressure of the optional cartridge that may have been includ-

ed with your unit is 2 grams. For all other cartridge systems please refer to the manufactures

specification included with the cartridge.

Anti-Skate:

The anti-skate adjustment prevents the Tone arm Assembly (4) from skipping across the record from

the centrifugal force that is caused spinning rotation of the Platter (2). The Anti-Skating (25) control

knob should be set to the same value as the stylus pressure. For example if your Counterweight (26)

is set to 2.5 grams the Anti-Skate (25) value should also be set to 2.5.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Nessun commento

American Audio DTI 1.8 Specifiche Pagina 11